Florabest FKS 2200 D2 Instrukcja Użytkownika Pobierz pdf (Strona 62)

62

GB

7. The power saw switches off when

you release the On/Off switch

(10) again. Switching for continu-

ous running is not possible.

Checking the chain brake

The motor cannot be turned on if

the chain brake has engaged. Do

not employ the chain brake in order

to start the chainsaw or to switch it

off.

E

1. Place the electric chainsaw onto

a solid, at surface. It must not

contact any objects.

2. Connect the device to the mains

voltage.

3. Release the chain brake by

shifting the brake arm (3) over

against the front grip (8).

4. Hold the electric chainsaw rmly

with both hands, with the right

hand on the rear handle (

A

1)

and the left hand on the front

handle (8). Thumb and nger

must close securely over the han-

dles.

5. Turn on the electric chainsaw.

6. Activate the chain braking lever

(3), with running motor, with

the left hand. To do so, push the

chain braking lever/front hand

protection (3) away from the front

handle (8). Chain should stop

abruptly.

7. Once the chain brake is work-

ing properly, release the on/off

switch (10) and the chain brake.

If the chain brake does not

function correctly, you must

not use the electric chainsaw.

A slack saw chain leads to

danger of injury.

Return the electric chainsaw

to our Service-Center for re-

pair.

Checking the chain

lubrication

Check the oil level and the chain lubrica-

tion system before commencement of work.

• Switch on the chainsaw and hold it

above a bright background. The saw

must not touch the ground.

If an oil trace can be seen, the chainsaw is

working trouble-free.

If no oil trace can be seen clean the

oil passages or turn the chainsaw

to our Service-Center for repair.

J

4. Clean the oil passages of the

chain bar (27), in order to guar-

antee a trouble-free, automatic

oiling of the saw chain during

operation.

Fitting the saw chain

G

1. Switch the saw off and unplug it

from the mains.

2. Spread the chain (5) out into a

loop with the cutting edges run-

ning clockwise .

3. Slide the saw chain (5) into the

bar guide groove. To mount the

guide bar (4), raise it to an angle

of approx. 45 degrees. This will

make it easier to replace the saw

chain (5) onto the sprocket (25).

It is normal that the saw chain (5)

is slack. Sagging in the chain is

normal.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 79 80

Komentarze do niniejszej Instrukcji

Brak uwag